- Hardware
- Tech-D.012 blades
Tech-D.012 blades
Tech-D.012 blades
Rectangular, double-sided blade
A pack of 100, double ground, 0.3mm (0.012”) thick blades, made from surgical steel in Sheffield, England. This is a higher-grade steel than most comparable blades on the market, giving increased durability and reduced blade tip wear/breakage. Blades are also oil free to ensure non-marking of material. This blade is used for bevel and vertical cutting in the Ultimat Futura, Flexo Plate Cutter. It can also be used with the Evolution3 Rocker head for the occasional cutting of aluminium composite panel, such as Dibond and Alupanel. The Rocker head is not a one-pass finished ACP cut like the SteelTrak, but by using a Tech-D.012 blade with a few careful strokes you can achieve a clean cut.
Rectangular, double-sided blade
A pack of 100, double ground, 0.3mm (0.012”) thick blades, made from surgical steel in Sheffield, England. This is a higher-grade steel than most comparable blades on the market, giving increased durability and reduced blade tip wear/breakage. Blades are also oil free to ensure non-marking of material. This blade is used for bevel and vertical cutting in the Ultimat Futura, Flexo Plate Cutter. It can also be used with the Evolution3 Rocker head for the occasional cutting of aluminium composite panel, such as Dibond and Alupanel. The Rocker head is not a one-pass finished ACP cut like the SteelTrak, but by using a Tech-D.012 blade with a few careful strokes you can achieve a clean cut.